Home > Products > High Head Micro Turgo> XJ10kW-30M

Turgo type single nozzle Hydro Turbine 10KW

Model No:XJ30-10DCT4-Z
Output/Power:10000 watt
Rated Head:30 – 38 Meters
Rated Flow:40 – 50 (l/s)

XJ30-10SCT4 is a AC direct systems consist of a turbine-generator unit producing AC power which is used as needed.  That is, it is fed directly to the appliances. No need of battery and inverter, XJ30-10SCT4/ offers a complete water to wire system with integral Turgo turbine, generator and valve flow control.  Designed to deliver ready-to-use 230V AC single phase power, it employs a brushless, special rare-earth permanent magnet  alternator and therefore has a higher efficiency than ordinary alternator.  Output voltage and frequency are controlled by the electronic load controller(with ballast). As little as 40 to 50 liter per second (l/s) falling 38 meter through a pipe, it can supply enough power to comfortably run a household.  This machine is compact, easy to install and  requires little maintenance except lubricating the bearing every few months.

OUTPUT IN WATTS against various head and flow
Water head
(meter)
Water flow(liter/second)
42 liter/sec
44 liter/sec
46 liter/sec
48 liter/sec
50 liter/sec
28
3528W
4928W
6440W
6720W
7700W
30
3780W
5280W
6900W
7200W
8250W
32
4032W
5632W
7360W
7680W
8800W
34
4284W
5984W
7820W
8160W
9350W
36
4536W
6336W
8280W
8640W
9900W
38
4788W
6688W
8740W
9120W
10000W

The Turgo turbine was designed for families in remote areas to produce power for their households easily and inexpensively. These units have been incredibly successful and today thousands are installed throughout the world.
These turbines need very little water flow to run efficiently and produce significant power out. The standard configuration uses one nozzle
Water is collected upstream from the turbine and channeled in a pipe down to the turbine location. At the turbine, the water passes through a nozzle, where it accelerates, strike the turbine runner, and turn a AC three-phase brushless permanent magnet alternator. A electric load controller is built on the alternator which stabilizes the voltage to 380V to protect electrical appliances during use. Installation is very simple and explained in the manual. Once installed there are no running costs and the maintenance costs are very low.

If you feel you may have a suitable site, please email specific information on your actual site. The information that is required for a preliminary assessment is:
1. The volume of water flowing in your stream, expressed as liters per second.
2. The head (height of drop) of the falling water, expressed in meters.
3. The length of the penstock (pipeline) in meters.

 

Related Products